Mattress Mate™ Slip-On Dust Mite Mattress Protector | AU

Mattress Mate™ Slip-On Dust Mite Mattress Protector

A slip-on quilted mattress protector with a cotton top tested for harmful substances according to OEKO-TEX® Standard 100, soft polyester filling, and TPU waterproof backing. Sits over the top of a dust mite mattress encasement and goes through your normal weekly wash with the bed linen — so the encasement underneath stays cleaner for longer. Wide elastic corner straps fit Australian mattresses 16–40cm deep. Available Cot, Single, Long Single, King Single, Double, Queen, King, and Super King.

At a glance

• Construction: Cotton front (tested for harmful substances according to OEKO-TEX® Standard 100), soft polyester filling, TPU waterproof rear lining
• Front pore size: Most common pore size approximately 2.7 microns (third-party capillary flow porometry, Galwick fluid)
• Rear pore size: Approximately 0.16 microns at maximum distribution (third-party capillary flow porometry, Galwick fluid)
• Fit: Slip-on with wide elastic corner straps — fits mattresses 16–40cm deep
• Coverage: Sits over the top of a dust mite mattress encasement
• Waterproof: Yes — TPU rear lining blocks liquid spills, sweat, and accidents
• Care: Machine washable on warm/gentle cycle
• Warranty: 12-month voluntary warranty against manufacturing defects — see our Refund Policy for full terms

What this product is

A slip-on quilted protector that goes over your dust mite mattress encasement and absorbs the daily wear, sweat, and spills that would otherwise build up on the encasement itself. Both faces of the protector are pore-tested fabric — cotton on the front, TPU-laminated knit on the rear — so the polyester filling stays clean and what reaches the encasement underneath is a fraction of what reaches the protector.

• How the layered system works. The encasement underneath seals the mattress; the Mattress Mate over the top takes the daily contact. Allergens, skin cells, and spills collect on the surface of the Mattress Mate, where the cotton front holds them. A weekly wash with your normal bed linen cleans them off — the encasement underneath stays cleaner for longer and washes far less often.
• How the fabric layers work as a particle barrier. The cotton front has a most common pore size of approximately 2.7 microns; the TPU rear lining has pores measured at approximately 0.16 microns at maximum distribution (both third-party capillary flow porometry, Galwick fluid). Both faces have a most common pore size well below the typical 10–40 micron size of dust mite particles.
• Used alongside other dust mite reduction measures. A Mattress Mate over an encasement is one piece of dust mite reduction in the bedroom, alongside regular vacuuming, hard-floor surfaces where possible, and reduced soft furnishings. If you have a diagnosed condition, discuss bedding choices with your GP or allergist.

Who this is for

• People who already own a dust mite mattress encasement and want a wash-weekly top layer that takes the daily wear
• People who want a waterproof layer over the mattress and a fabric that can be used as a dust mite particle barrier
• Households where the encasement underneath needs to stay cleaner for longer — the Mattress Mate goes through the wash; the encasement washes less often
• People who want cotton tested for harmful substances according to OEKO-TEX® Standard 100 against the skin alongside waterproof protection

It's probably not the right fit if:

• You don't have a dust mite mattress encasement underneath — see our waterproof mattress encasements or cotton mattress encasements first
• Your mattress is over 40cm deep — measure first; the elastic corner straps fit up to ~40cm
• You're looking for a barrier as your only mattress layer — this is designed as a topping over an encasement, not a standalone

What the fabric does

Dust mite allergens are carried by fecal pellets and body fragments that typically measure 10 to 40 microns. This product has two pore-tested faces, both well below that range:

• Cotton front (tested for harmful substances according to OEKO-TEX® Standard 100). Most common pore size approximately 2.7 microns (third-party capillary flow porometry, Galwick fluid). Skin-side surface is natural fibre, breathable, and absorbs daily wear.
• TPU rear lining. Approximately 0.16 microns at maximum distribution (third-party capillary flow porometry, Galwick fluid). Fully waterproof — blocks liquid spills, sweat, and accidents from reaching the encasement underneath.
• Quilted polyester filling. Soft, breathable, holds the cotton front and TPU rear apart.
• Wide elastic corner straps. Slip-on fit — no zipper, no removal of the mattress to install.

Sizing

Wide elastic corner straps fit standard Australian mattresses 16–40cm deep. No zipper.

How to fit it

1. Place your dust mite mattress encasement on the mattress first (or check it's already fitted).
2. Lay the Mattress Mate over the top.
3. Pull each elastic corner strap under the corner of the mattress.
4. Smooth the fabric flat. Fitted sheets and bed linen go over the top as normal.

Care

• Wash: Machine wash on a warm or gentle cycle. Avoid hot water — high temperatures can damage the TPU lining over time.
• Frequency: Weekly with your bed linen.
• Dry: Tumble dry on warm. Avoid prolonged hot drying.
• Avoid: Bleach, ironing, natural and body oils outside of normal use.
• Front-loaders: Use a gentle setting in front-load washers.

Materials and testing

• Front: cotton tested for harmful substances according to OEKO-TEX® Standard 100, with a most common pore size of approximately 2.7 microns (third-party capillary flow porometry, Galwick fluid).
• Filling: Soft polyester quilt filling.
• Rear lining: TPU (thermoplastic polyurethane) waterproof membrane, approximately 0.16 microns at maximum distribution (third-party capillary flow porometry, Galwick fluid).

Pore-size figures are from a third-party laboratory test report provided by our manufacturer; a copy is available on request.

We don't make claims that the product cures, treats, or prevents allergies, asthma, or any medical condition. What we describe is the fabric's measurable physical properties as a barrier against fine particles and liquids.

Pairs well with

• Waterproof mattress encasements — the Mattress Mate is designed to layer over a mattress encasement
• Cotton mattress encasements — the natural-fibre alternative beneath the Mattress Mate
• Dust mite pillow protectors — for the pillows on the bed

Frequently asked questions

Do I need a separate mattress encasement underneath?

Yes — the Mattress Mate is designed to layer over an encasement. The encasement seals the mattress; the Mattress Mate sits on top and absorbs the daily wear so the encasement stays cleaner.

How often should I wash it?

Weekly, with your bed linen.

Will it fit my mattress?

Slip-on with elastic corner straps, fits 16–40cm deep across all standard Australian sizes.

Is the cotton front tested to OEKO-TEX® Standard 100?

Yes — the cotton front is tested for harmful substances according to OEKO-TEX® Standard 100.

Does it block bed bugs?

The pore structure of both fabric faces is well below the size of bed bugs or their eggs. The Mattress Mate is a wash-weekly top layer, not a sealed encasement, so bed-bug isolation should always come from the encasement underneath.

Is it suitable for incontinence or bedwetting?

Yes — the TPU rear lining is fully waterproof. For heavy or repeated wetting, wash sooner.

What's the warranty?

This product carries our 12-month voluntary warranty against manufacturing defects, in addition to your Australian Consumer Law rights. See our Refund Policy for full terms.